D-Link DGS-3130 Emulator - Page 716

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to specify the default metric for routes redistributed from other routing protocols. If the routes being redistributed are learned from other protocols, then they have an incompatible metric as IPv6 RIP. Respecifying of metric allows the metric to be synced. Example This example shows how to configure the default metric as 5 for the routes redistributed to RIPng. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# default-metric 5 Switch(config-rtr)# redistribute ospf Switch(config-rtr)# 69-3 distance (RIPng) This command is used to define an administrative distance of routes learned by IPv6 routing protocols. Use the no form of this command to revert to the default setting. distance DISTANCE no distance Parameters DISTANCE Specifies the administrative distance. The range is from 1 to 254. The lower value represents better route. Default By default, the RIPng distance is 120. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline The distance is an integer from 1 to 254 representing the trust rating of the route. The route with a lower distance value is preferred over the route with the higher distance value. Example This example shows how to configure the distance of RIPng routes to 100. 712