D-Link DGS-3130 Emulator - Page 849

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide DESTINATION-URL LOCATION If attack-log UNIT-ID is specified as the SOURCE-URL, the purpose is to upload one unit's attack log. Specifies the destination URL for the copied file. One special form of the URL is represented by the following keywords. If running-config is specified as the DESTINATION-URL, the purpose is to apply a configuration to the running configuration. If startup-config is specified as the DESTINATION-URL, the purpose is to save a configuration to the next-boot configuration. That is to keep the current configuration into the NVRAM and the file name will be the same as the file name specified with the boot config command. If flash: [PATH-FILE-NAME] is specified as the DESTINATION-URL, the purpose is to specify the copied file in the file system. If the input relative path is specified, the file will be downloaded to all units in stack and stored in the current path of each unit. If the input absolute path is specified, the file will be downloaded to the place which of the absolute path indicates. If there is no unit information in the absolute path, the master unit will be assigned. Specifies the IPv4 address the TFTP/FTP/RCP server, or IPv6 address of the TFTP/FTP server. Default None. Command Mode Privileged EXEC Mode. Command Default Level Level: 15. Usage Guideline Use this command to copy a file to another file in the file system. Use this command to download or upload the configuration file or the image file. Use this command to upload the system log to the TFTP server. To upload the running configuration or save the running configuration to the startup configuration, specify running-config as the SOURCE-URL. To save the running configuration to the startup configuration, specify startup-config as the DESTINATION-URL. As the destination is the startup configuration, the source file is directly copied to the file specified in the boot config command. Thus the original startup configuration file will be overwritten. To apply a configuration file to the running configuration, specify running-config as the DESTINATION-URL for the copy command and the configuration file will be executed immediately by using the increment method. That means that the specified configuration will merge with the current running configuration. The running configuration will not be cleared before applying of the specified configuration. As the specified source is the system log and the specified destination is a URL, the current system log will be copied to the specified URL. To represent a file in the remote TFTP server, the URL must be prefixed with "tftp: //". To download the firmware image, the user should use the copy tftp: // command to download the file from the TFTP server to a file in the file system. Then, use the boot image command to specify it as the boot image file. Example This example shows how to configure the Switch's running configuration by using the increment method using the configuration called "switch-config.cfg" that is download from the TFTP server 10.1.1.254. 845