D-Link DGS-3130 Emulator - Page 666

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface ethernet 1/0/5 Switch(config-if)# rate-limit input 2000 4096 Switch(config-if)# 63-20 service-policy This command is used to attach a policy map to the input or output type on an interface. Use the no form of this command to remove a service policy from an input interface. service-policy {input | output} NAME no service-policy {input | output} Parameters input output NAME Specifies to apply the policy map for ingress flow on the interface. Specifies to apply the policy map for egress flow on the interface. Specifies the name of a service policy map. The name can be a maximum of 32 alphanumeric characters. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to attach at most one policy map for each type (input or output) on an interface. This policy is attached to the interface for aggregate and controls the number or rate of packets. A packet arriving at a port will be treated based on the service policy attached to the interface. Example This example shows how two policy maps are defined: (1) cust1-classes and (2) cust2-classes. For cust1-classes, gold is configured to match CoS 6 and be policed by a single rate policer with a committed rate of 800 Kbps. Silver is configured to match CoS 5 and be policed by a single rate policer with a committed rate of 2000Kbps, and bronze is configured to match CoS 0 and be policed by a single rate policer with a committed rate of 8000Kbps. For cust2-classes, gold is configured to use Cos Queue 6 and be policed by a single rate policer with a committed rate of 1600 Kbps. Silver is policed by a single rate policer with a committed rate of 4000 Kbps, and bronze is policed by a single rate policer with a committed rate of 16000 Kbps. The cust1-classes policy map is configured and then attached to interfaces ethernet 1/0/1 and 1/0/2 for ingress traffic. 662