D-Link DGS-3130 Emulator - Page 556

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# vlan 1 Switch(config-vlan)# ipv6 mld snooping mrouter interface ethernet 1/0/1 Switch(config-vlan)# ipv6 mld snooping mrouter forbidden interface ethernet 1/0/2 Switch(config-vlan)# This example shows how to disables the auto-learning of routing protocol packets. Switch# configure terminal Switch(config)# vlan 4 Switch(config-vlan)# no ipv6 mld snooping mrouter learn pimv6 Switch(config-vlan)# 52-8 ipv6 mld snooping ignore-topology-change-notification This command is used to make MLD snooping ignore STP changes and not send an STP triggered query on the interface. Use the no form of this command to make MLD snooping aware STP changes and send an STP triggered query on the specified interface. ipv6 mld snooping ignore-topology-change-notification no ipv6 mld snooping ignore-topology-change-notification Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is only available for VLAN interface configuration. An MLD snooping switch is aware of link-layer topology changes caused by Spanning Tree operation. When a port is enabled or disabled by Spanning Tree, a General Query will be sent on all active non-router ports in order to reduce network convergence time. Use this command to make MLD snooping ignore the topology changes. Example This example shows how to enable MLD snooping to ignore topology changes on VLAN 1. Switch# configure terminal Switch(config)# vlan 1 Switch(config-vlan)# ipv6 mld snooping ignore-topology-change-notification Switch(config-vlan)# 552