D-Link DGS-3130 Emulator - Page 452

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to display IGMP snooping filter information when no interface is specified. Switch#show ip igmp snooping filter eth1/0/1 Rate limit: Not Configured Access group: Not Configured Groups/Channel Limit: Not Configured vlan 1: Access group: Not Configured Groups/Channel Limit: 100 (Exception List: AccessList, exceed-action: drop) eth1/0/2 Rate limit: 10pps Access group: Not Configured Groups/Channel Limit: Not Configured vlan 1: Access group: Not Configured Groups/Channel Limit: 100 (Exception List: ExtendACL, exceed-action: drop) Switch# This example shows how to display filter information of Ethernet 1/0/2. Switch#show ip igmp snooping filter interface ethernet 1/0/2 eth1/0/2 Rate limit: 10pps Access group: Not Configured Groups/Channel Limit: Not Configured vlan 1: Access group: Not Configured Groups/Channel Limit: 100 (Exception List: ExtendACL, exceed-action: drop) Switch# 39-26 show ip igmp snooping mrouter This command is used to display IGMP snooping multicast router information that has been automatically learned and manually configured on the Switch. show ip igmp snooping mrouter [vlan VLAN-ID [, | -]] Parameters vlan VLAN-ID , - (Optional) Specifies the VLAN. If no VLAN is specified, IGMP snooping information on all VLANs will be displayed of which IGMP snooping is enabled. (Optional) Specifies a series of VLANs, or separate a range of VLANs from a previous range. No space is allowed before and after the comma. (Optional) Specifies a range of VLANs. No space is allowed before and after the hyphen. 448