D-Link DGS-3130 Emulator - Page 482
validate prefix
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 482 highlights
Parameters None. DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, this feature is enabled. Command Mode Source-guard Policy Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is used to enable the IPv6 source guard function to perform the validate address feature. Example This example shows how to disable the validate address feature. Switch# configure terminal Switch(config)# ipv6 source-guard policy policy1 Switch(config-source-guard)# no validate address Switch(config-source-guard)# 44-6 validate prefix This command is used to enable the IPv6 source guard function to perform the IPv6 prefix-guard operation. Use the no form of this command to disable this feature. validate prefix no validate prefix Parameters None. Default By default, this feature is disabled. Command Mode Source-guard Policy Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is used to enable the IPv6 source guard function to perform the IPv6 prefix-guard operation. 478