D-Link DGS-3130 Emulator - Page 133

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface vlan 2 Switch(config-if)# no ipv6 address dhcp-prefix 0:0:0:2::3/64 10-3 ipv6 address eui-64 This command is used to configure an IPv6 address on the interface using the EUI-64 interface ID. Use the no form of this command to delete an IPv6 address formed by the EUI-64 interface ID. ipv6 address IPV6-PREFIX/PREFIX-LENGTH eui-64 no ipv6 address IPV6-PREFIX/PREFIX-LENGTH eui-64 Parameters IPV6-PREFIX PREFIX-LENGTH Specifies the IPv6 prefix part for the configured IPv6 address. Specifies the length of the prefix. The prefix of the IPv6 address is also a local subnet on the interface. The prefix length must be smaller than 64. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline If the command is configured on an IPv6 ISTAP tunnel, the last 32 bits of the interface ID are constructed using the source IPv4 address of the tunnel. Example This example shows how to add an IPv6 address incidence. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# ipv6 address 3ffe:501:ffff:0::/64 eui-64 Switch(config-if)# 10-4 ipv6 address dhcp This command is used to configure an interface using DHCPv6 to get an IPv6 address. Use the no form of this command to disable the using of DHCPv6 to get an IPv6 address. ipv6 address dhcp [rapid-commit] no ipv6 address dhcp 129