D-Link DGS-3130 Emulator - Page 36

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 3-10 dot1x system-auth-control This command is used to globally enable IEEE 802.1X authentication on the Switch. Use the no form of this command to disable IEEE 802.1X authentication. dot1x system-auth-control no dot1x system-auth-control Parameters None. Default By default, this option is disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline The 802.1X authentication function restricts unauthorized hosts from accessing the network. Use the dot1x system-auth-control command to globally enable the 802.1X authentication control. When 802.1X authentication is enabled, the system will authenticate the 802.1X user based on the method list configured by the aaa authentication dot1x default command. Example This example shows how to enable IEEE 802.1X authentication globally on a switch. Switch# configure terminal Switch(config)# dot1x system-auth-control Switch(config)# 3-11 dot1x timeout This command is used to configure IEEE 802.1X timers. Use the no form of this command to revert to the default settings. dot1x timeout {server-timeout SECONDS | supp-timeout SECONDS | tx-period SECONDS} no dot1x timeout {server-timeout | supp-timeout | tx-period} Parameters server-timeout SECONDS supp-timeout SECONDS Specifies the number of seconds that the Switch will wait for the request from the authentication server before timing out the server. On timeout, the authenticator will send an EAP-Request packet to the client. The range is 1 to 65535. Specifies the number of seconds that the Switch will wait for the response from the supplicant before timing out supplicant messages other than the EAP request ID. The range is 1 to 65535 32