D-Link DGS-3130 Emulator - Page 719
poison-reverse, redistribute RIPng
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 719 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to configure an IPv6 RIP routing process. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# 69-7 poison-reverse This command is used to enable the poison reverse processing for an IPv6 RIP process. Use the no form of this command to disable the poison-reverse processing. poison-reverse no poison-reverse Parameters None. Default By default, this option is disabled. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline Use the poison reverse command to enable the poison reverse mechanism in RIP routing updates. When poison reverse is enabled, the routes learned from an interface will be advertised out to the same interface with an unreachable metric. Example This example shows how to enable poison reverse for IPv6 RIP. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# poison-reverse Switch(config-rtr)# 69-8 redistribute (RIPng) This command is used to redistribute routes from other routing domains into RIP. Use the no form of this command to disable route redistribution from specific protocols. redistribute PROTOCOL [metric METRIC-VALUE] no redistribute PROTOCOL 715
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/719.png)