D-Link DGS-3130 Emulator - Page 98

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide system start-stop default METHOD1 [METHOD2...] Specifies to perform accounting for system-level events. Specifies to send accounting messages at both the start time and the end time of access. Users are allowed to access the network regardless of whether the start accounting message enables the accounting successfully. Specifies to configure the default method list for system accounting. Specifies the list of methods that the accounting algorithm tries in the given sequence. Enter at least one method or enter up to four methods. The following are keywords that can be used to specify a method. group radius - Specifies to use the servers defined by the RADIUS server host command. group tacacs+ - Specifies to use the servers defined by the TACACS+ server host command. group GROUP-NAME - Specifies to use the server groups defined by the AAA group server command. none - Specifies no to perform accounting. Default No AAA accounting method is configured. Command Mode Global Configuration Mode. Command Default Level Level: 15. Usage Guideline Use this command to configure the accounting method list for system-events such as reboot, reset events. For the default method list to take effect, enable AAA first by using the aaa new-model command. The accounting system is disabled if the default method list is not configured. Example This example shows how to enable accounting of the system events using RADIUS and sends the accounting messages while system event occurs: Switch#configure terminal Switch(config)# aaa accounting system default start-stop group radius Switch(config)# 8-5 aaa authentication enable This command is used to configure the default method list used for determining access to the privileged EXEC level. Use the no form of this command to remove the default method list. aaa authentication enable default METHOD1 [METHOD2...] no aaa authentication enable default 94