D-Link DGS-3130 Emulator - Page 820
stack priority
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 820 highlights
Parameters oldunit newunit DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide The current switch identifier on the switch whose identifier is to be changed. The update value of the switch identifier. Default The unit ID is assigned automatically. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Upon command execution, the switch will be configured with the configuration information for the new switch, if any. The old switch configuration information will be retained, however the old switch will be operationally unplugged. This command is executed on the Primary Master Box. NOTE: If the Primary Master Box is renumbered, then the running configuration is no longer applied (i.e. the stack acts as if the configuration had been cleared). Example The following example shows how to renumber switch identifier of the Primary Master switch unit 1 to 3: Switch(config)#switch 1 renumber 3 All the switches in the stack will be reset to perform Manager unit renumbering and the configuration of Manager switch interfaces will be cleared. Are you sure you want to renumber? (y/n) y Rebooting system! The following example shows how to renumber switch identifier of a slave switch unit 7 to 5: Switch(config)#switch 7 renumber 5 All the switches in the stack will be reset to perform Manager unit renumbering and the configuration of Manager switch interfaces will be cleared. Are you sure you want to renumber? (y/n) y Switch(config)# 79-4 stack priority This command is used to configure the priority of the switch stacking unit. Use the no form of this command to revert to the default setting. stack unit priority value no stack unit priority Parameters unit The switch identifier. 816