D-Link DGS-3130 Emulator - Page 561

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline The command is available for VLAN interface configuration, physical port or port-channel interface. The command configures the rate of MLD control packets that are allowed per interface. Example This example shows how to limit 30 packets per second on interface VLAN 1000. Switch# configure terminal Switch(config)# vlan 1000 Switch(config-vlan)# ipv6 mld snooping rate-limit 30 Switch(config-vlan)# 52-15 ipv6 mld snooping report-suppression This command is used to enable MLD report suppression on a VLAN. Use the no form of this command to disable report suppression on a VLAN. ipv6 mld snooping report-suppression no ipv6 mld snooping report-suppression Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is only available for VLAN interface configuration. The report suppression function only works for MLDv1 traffic. When report suppression is enabled, the Switch suppresses duplicate reports sent by hosts. Suppression for the same group report or leave messages will continue until the suppression time expires. For report or leave messages to the same group, only one report or leave message is forwarded. The remaining report and leave messages are suppressed. Example This example shows how to enable MLD report suppression. Switch# configure terminal Switch(config)# vlan 100 Switch(config-vlan)# ipv6 mld snooping report-suppression Switch(config-vlan)# 557