D-Link DGS-3130 Emulator - Page 421
show interfaces counters
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 421 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#show interfaces ethernet 1/0/1 Eth1/0/1 is enabled link status is up Interface type: 1000BASE-T Interface description: MAC Address: F0-7D-68-36-31-B0 Auto-duplex, auto-speed, auto-mdix Send flow-control: off, receive flow-control: off Send flow-control oper: off, receive flow-control oper: off Full-duplex, 100Mb/s Maximum transmit unit: 1536 bytes RX rate: 464 bits/sec, TX rate: 0 bits/sec RX bytes: 40795, TX bytes: 29789 RX rate: 0 packets/sec, TX rate: 0 packets/sec RX packets: 559, TX packets: 61 RX multicast: 43, RX broadcast: 0 RX CRC error: 0, RX undersize: 0 RX fragment: 0, RX dropped Pkts: 100 RX MTU exceeded: 0 TX CRC error: 0, TX excessive deferral: 0 TX single collision: 0, TX excessive collision: 0 TX late collision: 0, TX collision: 0 Switch# This example shows how to display the interface information for management port 0. Switch#show interfaces mgmt 0 mgmt_ipif 0 is enabled, Link status is up Interface type: Management port Switch# 38-7 show interfaces counters This command is used to display counters on specified interfaces. show interfaces [INTERFACE-ID [, | -]] counters [errors] Parameters INTERFACE-ID , errors (Optional) Specifies that the interface can be a physical port or VLAN interfaces. If no interface is specified, the counters on all interfaces will be displayed. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. (Optional) Specifies to display the error counters. Default None. 417
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/421.png)