D-Link DGS-3130 Emulator - Page 883

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#show protocol-vlan profile Profile ID ---------1 2 3 Frame-type ----------Ethernet2 Ethernet2 Ethernet2 Ether-type 0x86DD(IPv6) 0x0800(IP) 0x0806(ARP) Total Entries: 3 Switch# 89-7 show vlan This command is used to display the parameters for all configured VLANs or one VLAN on the Switch. show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]] | mac-vlan] Parameters VLAN-ID , interface INTERFACE-ID , mac-vlan (Optional) Specifies a list of VLANs to display the member port information. If the VLAN is not specified, all VLANs are displayed. The valid range is from 1 to 4094. (Optional) Specifies a series of VLANs, or separate a range of VLANs from a previous range. No space is allowed before and after the comma. (Optional) Specifies a range of VLANs. No space is allowed before and after the hyphen. (Optional) Specifies the port to display the VLAN related setting. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. (Optional) Specifies to display MAC-based VLAN information. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline This command is used to display the parameters for all configured VLANs or one VLAN on the Switch. Example This example shows how to display all the current VLAN entries. 879