D-Link DGS-3130 Emulator - Page 689
Route Map Commands
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 689 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 66. Route Map Commands 66-1 match interface This command is used to define a clause to match the route's outgoing interface. Use the no form of this command to remove the clause. match interface INTERFACE-ID no match interface Parameters INTERFACE-ID Specifies the outgoing interface. Default None. Command Mode Route-map Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command in the route-map configuration mode to define rules for matching routes against outgoing interfaces. Example This example shows how to create a route map entry to match against the outgoing interface. Switch# configure terminal Switch(config)# route-map myPolicy permit 1 Switch(config-route-map)# match interface vlan 1 Switch(config-route-map)# 66-2 match ip address This command is used to define a clause to match the route based on the standard IP access list or IP prefix list. Use the no form of this command to remove the clause. match ip address {ACCESS-LIST-NAME} no match ip address {ACCESS-LIST-NAME} Parameters ACCESS-LIST-NAME Specifies a standard or an extended IP access list name. Default None. 685