D-Link DGS-3130 Emulator - Page 321
Dynamic ARP Inspection Commands
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 30. Dynamic ARP Inspection Commands 30-1 arp access-list This command is used to create or modify an ARP access list. This command will enter into the ARP access-list configuration mode. Use the no form of this command to remove an ARP access-list. arp access-list NAME no arp access-list NAME Parameters NAME Specifies the name of the ARP access-list to be configured. The maximum length is 32 characters. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline The name must be unique among all access-lists. The characters used in the name are case sensitive. There is an implicit deny statement at the end of an access list. Example This example shows how to configure an ARP access list with two permit entries. Switch# configure terminal Switch(config)# arp access-list static-arp-list Switch(config-arp-nacl)# permit ip 10.20.0.0 0.0.255.255 mac any Switch(config-arp-nacl)# permit ip 10.30.0.0 0.0.255.255 mac any Switch(config-arp-nacl)# 30-2 clear ip arp inspection log This command is used to clear the ARP inspection log buffer. clear ip arp inspection log Parameters None. Default None. 317
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/321.png)