D-Link DGS-3130 Emulator - Page 636

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline Use this command to configure the distance is an integer from 1 to 255 representing the trust rating of the route. The route with a lower distance value is preferred over the route with a higher distance value. A route with the distance 255 will not be installed for routing of packets since it indicates that the route is not trusted. If the distance command is used without parameters, the specified distance becomes the default value for routes of the configured protocol. Example This example shows how to configure the static route distance to 100. Switch# configure terminal Switch(config)# distance static 100 Switch(config)# 62-4 distribute-list in This command is used to configure the distribute list which filters the protocol route updates based on the specified access list. Use the no form of this command to remove the filter. distribute-list ACCESS-LIST-NAME in [INTERFACE-ID] no distribute-list ACCESS-LIST-NAME in [INTERFACE-ID] Parameters ACCESS-LIST-NAME INTERFACE-ID Specifies a standard IP access list to define which received route updates are to be accepted and which route updates are to be advertised. (Optional) Specifies the interface to apply the distribute list. Default None. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline When the access list is applied to the interface using the distribute-list in command, the route updates received by the specified interface will be filtered based on the access list. If the interface ID is specified, the distribute-list is applied to the specified interface. If the interface ID is not specified, the distribute list is applied to all interfaces. Example This example shows how to configure access list "East-ranch" to filter RIP protocol route updates. 632