D-Link DGS-3130 Emulator - Page 927

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 94-2 random-detect exponential-weight This command is used to configure the WRED exponential weight factor for the average queue size calculation for the queue. Use the no form of this command to revert to the default setting. random-detect exponential-weight COS-VALUE exponent VALUE no random-detect exponential-weight COS-VALUE Parameters COS-VALUE exponent VALUE Specifies CoS queues on which the exponent will be set. The valid range is from 0 to 7. Specifies the exponent value from 0 to 15. Default The default exponential weight factor is 9. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to configure the WRED exponential weight factor for the average queue size calculation for the queue. Example This example shows how to configure the exponent value to 10 on Ethernet 1/0/1 queue 5. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# random-detect exponential-weight 5 exponent 10 Switch(config-if)# 94-3 random-detect profile This command is used to configure the WRED profile. Use the no form of this command to revert to the default setting. random-detect profile ID [green | yellow | red] min-threshold VALUE max-threshold VALUE max-droprate VALUE no random-detect profile ID Parameters ID green yellow Specifies the ID of the WRED profile that will be set. (Optional) Specifies the WRED drop parameters for green packets to be set. (Optional) Specifies the WRED drop parameters for yellow packets to be set. 923