D-Link DGS-3130 Emulator - Page 660

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 63-14 police aggregate This command is used to configure a named aggregate policer as the policy for a traffic class in a policy map. Use the no form of this command to delete the name aggregate policer from a class policy. police aggregate NAME no police Parameters NAME Specifies a previously defined aggregate policer name as the aggregate policer for a traffic class. Default None. Command Mode Policy-map Class Configuration Mode. Command Default Level Level: 12. Usage Guideline Use the mls qos aggregate-policer command in the global configuration mode to create a named aggregate policer. Then use the police aggregate command in the policy-map class configuration mode to configure the named aggregate policer as the policy for a traffic class. A named aggregate policer cannot be referenced from a different policy map. If a named aggregate policer is attached to multiple ingress ports, the metering operation of the policer will not be applied to the aggregate traffic but remains applied to the traffic received on the individual port. Example This example shows how to configure a named aggregate policer's parameters and apply the policer to multiple classes in a policy map: An aggregate policer with single rate policing named "agg_policer1" is created. This policer is configured as the policy for traffic class 1, 2, and 3. Switch# configure terminal Switch(config)# mls qos aggregate-policer agg_policer1 10000 16384 exceed-action drop Switch(config)# policy-map policy2 Switch(config-pmap)# class class1 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# exit Switch(config-pmap)# class class2 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# exit Switch(config-pmap)# class class3 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# 656