Dell Force10 S4820T FTOS Command Reference Guide - Page 1002

www.dell.com | support.dell.com The starting point for using LLDP is invoking LLDP with the protocol lldp command in either the CONFIGURATION or INTERFACE mode. The information distributed by LLDP is stored by its recipients in a standard Management Information Base (MIB). The information can be accessed by a network management system through a management protocol such as SNMP. the Link Layer Discovery Protocol chapter of the FTOS Configuration Guide for details on implementing LLDP/LLDP-MED. advertise dot1-tlv c e s Advertise dot1 TLVs (Type, Length, Value). Syntax Parameters Defaults Command Modes Command History Related Commands advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name} To remove advertised dot1-tlv, use the no advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name} command. port-protocol-vlan-id port-vlan-id vlan-name Enter the keyword port-protocol-vlan-id to advertise the port protocol VLAN identification TLV. Enter the keyword port-vlan-id to advertise the port VLAN identification TLV. Enter the keyword vlan-name to advertise the vlan-name TLV. This keyword is only supported on C-Series and S-Series. Disabled CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 8.3.19.0. Version 8.3.7.0. Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on S4810 Introduced on S-Series, added vlan-name option. Introduced on C-Series Introduced on E-Series protocol lldp (Configuration) debug lldp interface show lldp neighbors show running-config lldp Enable LLDP globally. Debug LLDP Display the LLDP neighbors Display the LLDP running configuration 1002 | Link Layer Discovery Protocol (LLDP)