Dell Force10 S4820T FTOS Command Reference Guide - Page 135

Voltage : ok Serial Number : 0016788 Part Number : 7520013800 Rev 01 Vendor Id : 01 Date Code : 06182004 Country Code : 01 FTOS# Table 4-7 defines the fields displayed in the previous example. Table 4-7. Descriptions of show rpm output Field Status Next Boot Card Type Hardware Rev Num Ports Up Time Last Restart FTOS Version Jumbo Capable CP Boot Flash RP1 Boot Flash RP2 Boot Flash CP Mem Size RP1 Mem Size PR2 Mem Size Description Displays the RPM's status. Displays whether the RPM is to be brought online at the next system reload. Displays the RPM catalog number. Displays theE-Series chipset hardware revision level: 1.0 (non-Jumbo); 1.5 (Jumbo-enabled); 2.0 (or above is TeraScale). Displays the number of active ports. Displays the number of hours and minutes since the RPM's last reboot. States the reason for the last RPM reboot. C-Series possible values: • "normal power-cycle" (reset power-cycle command) • "reset by master" (peer RPM reset by master RPM) • "over temperature shutdown" • "power supply failed" E-Series possible values: • "normal power-cycle" (insufficient power, normal power cycle) • "reset by user" (automatic failover, software reload of both RPMs, or master RPM resetting peer) • "force-failover" (redundancy force-failover command) Displays the operating software version. Displays a Yes or No indicating if the RPM is capable of sending and receiving Jumbo frames. This field does not indicate if the chassis is in Jumbo mode; for that determination, use the show chassis brief command. Displays the two possible Boot Flash versions for the Control Processor. The [Booted] keyword next to the version states which version was used at system boot. Displays the two possible Boot Flash versions for the Routing Processor 1. The [Booted] keyword next to the version states which version was used at system boot. Displays the two possible Boot Flash versions for the Routing Processor 2. The [Booted] keyword next to the version states which version was used at system boot. Displays the memory of the Control Processor. Displays the memory of the Routing Processor 1. Displays the memory of the Routing Processor 2. Control and Monitoring | 135