Dell Force10 S4820T FTOS Command Reference Guide - Page 1212
rate shape
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1212 highlights
www.dell.com | support.dell.com E-Series On one interface, you can configure the rate limit or rate police command for a VLAN or you can configure the rate limit or the rate police command for the interface. For each physical interface, you can configure six rate police commands specifying different VLANS. After configuring VLANs in the rate police command, if this error message appears: %Error: Specified VLANs overlap with existing config. Check to if the same VLANs are used with the rate limit command on other interfaces. To clear the problem, remove the rate limit configuration(s), and re-configure the rate police command. After the rate police command is configured, return to the other interfaces and re-apply the rate limit configuration. Related Commands rate-police Police traffic output as part of the designated policy. rate shape c e s Shape the traffic output on the selected interface. Syntax rate shape [kbps] rate [burst-KB] Parameters kbps rate burst-KB Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series make the following value a multiple of 64. The default granularity is Megabits per second (Mbps). Range: 0-10000000 Enter the outgoing rate in multiples of 10 Mbps. Range: 10 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 0 to 10000 Default: 10 Defaults Granularity for rate is Mbps unless the kbps option is used. Command Modes INTERFACE Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 8.2.1.0 Added kbps option on C-Series, E-Series, and Series. Version 7.6.1.0 Introduced on S-Series and on C-Series pre-Version 6.1.1.1 Introduced on E-Series 1212 | Quality of Service (QoS)