Dell Force10 S4820T FTOS Command Reference Guide - Page 336

www.dell.com | support.dell.com Related Commands router bgp Enter ROUTER mode on the switch. distance bgp c e s Configure three administrative distances for routes. Syntax Parameters Defaults Command Modes distance bgp external-distance internal-distance local-distance To return to default values, enter no distance bgp. external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. Range: 1 to 255 Default: 20 Enter a number to assign to routes learned from a router within the AS. Range: 1 to 255 Default: 200 Enter a number to assign to routes learned from networks listed in the network command. Range: 1 to 255 Default: 200 external-distance = 20; internal-distance = 200; local-distance = 200 ROUTER BGP Caution: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. Usage Information Command History The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series 336 | Border Gateway Protocol IPv4 (BGPv4)