Dell Force10 S4820T FTOS Command Reference Guide - Page 879
To remove a network, use the, The E-Series software resolves the network address con d by
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 879 highlights
Usage Information The first time you enter this command it configures the neighbor as a route reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a route reflector. When all clients of a route reflector are disabled, the neighbor is no longer a route reflector. network c e Specify the networks for the BGP process and enter them in the BGP routing table. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands network ipv6-address [route-map map-name] To remove a network, use the no network ipv6-address [route-map map-name] command. ipv6-address route-map map-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale The E-Series software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. redistribute Redistribute routes into BGP. IPv6 Border Gateway Protocol (IPv6 BGP) | 879