Dell Force10 S4820T FTOS Command Reference Guide - Page 698

www.dell.com | support.dell.com ip max-frag-count c e s Set the maximum number of fragments allowed in one packet for packet re-assembly. Syntax Parameters Defaults Command Modes Command History Usage Information ip max-frag-count count To place no limit on the number of fragments allowed, enter no ip max-frag-count. count Enter a number for the number of fragments allowed for re-assembly. Range: 2 to 256 No limit is set on number of fragments allowed. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low. ip mtu e Syntax Parameters Defaults Command Modes Set the IP MTU (frame size) of the packet transmitted by the RPM for the line card interface. If the packet must be fragmented, FTOS sets the size of the fragmented packets to the size specified in this command. ip mtu value To return to the default IP MTU value, enter no ip mtu. value Enter the maximum MTU size if the IP packet is fragmented. Default: 1500 bytes Range: 576 to 9234 1500 bytes INTERFACE (Gigabit Ethernet and 10 Gigabit Ethernet interfaces) 698 | IPv4 Routing