Dell Force10 S4820T FTOS Command Reference Guide - Page 260

www.dell.com | support.dell.com • If the next route map entry does not contain a continue clause, the route map evaluates normally. If a match does not does not occur, the route map does not continue and will fall through to the next sequence number, if one exists. Set clause with Continue clause If the route-map entry contains sets with the continue clause, then set actions is performed first followed by the continue clause jump to the specified route map entry. Related Commands • If a set actions occurs in the first route map entry and then the same set action occurs with a different value in a subsequent route map entry, the last set of actions overrides the previous set of actions with the same set command. • If set community additive and set as-path prepend are configure, the communities and AS numbers are pre-pended. set community set as-path Specify a COMMUNITY attribute Configure a filter to modify the AS path description c e s Add a description to this route map. Syntax description {description} Parameters description Enter a description to identify the route map (80 characters maximum). Defaults No default behavior or values Command Modes ROUTE-MAP Command History Version 8.1.1.0 Introduced on E-Series ExaScale pre-Version 7.7.1.0 Introduced Related Commands route-map Enable a route map match as-path c e s Configure a filter to match routes that have a certain AS number in their BGP path. Syntax match as-path as-path-name Parameters as-path-name Enter the name of an established AS-PATH ACL, up to 140 characters. Defaults Not configured. 260 | Access Control Lists (ACL)