Dell Force10 S4820T FTOS Command Reference Guide - Page 613

Related Commands FTOS(conf-if-lo-1655)# interface interface null interface port-channel interface vlan Configure a physical interface. Configure a Null interface. Configure a port channel. Configure a VLAN. interface ManagementEthernet c e s Configure the Management port on the system (either the Primary or Standby RPM). Z Syntax interface ManagementEthernet slot/port Parameters slot/port Enter the keyword ManagementEthernet followed by slot number (0-1) and port number zero (0). Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.11.1 Version 8.3.11.1 Version 8.1.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on S4820T Introduced on Z9000 Introduced on S55, S60 and S4810 Introduced on E-Series ExaScale Introduced for C-Series Introduced for E-Series Example Usage Information FTOS(conf)#interface managementethernet 0/0 FTOS(conf-if-ma-0/0)# You cannot delete a Management port. The Management port is enabled by default (no shutdown). Use the ip address command to assign an IP address to the Management port. If two RPMs are installed in your system, use the show redundancy command to display which RPM is the Primary RPM. Related Commands management route duplex (Management) speed (Management interface) Configure a static route that points to the Management interface or a forwarding router. Clear FIB entries on a specified line card. Clear FIB entries on a specified line card. Interfaces | 613