Dell Force10 S4820T FTOS Command Reference Guide - Page 780

www.dell.com | support.dell.com ipv6 unicast-routing c e s Enable IPv6 Unicast routing. Syntax ipv6 unicast-routing Defaults Command Modes To disable unicast routing, use the no ipv6 unicast-routing command. Enabled CONFIGURATION Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S4820T Introduced on the S4810 Introduced on S-Series Introduced on E-Series ExaScale Introduced on C-Series Introduced on E-Series TeraScale Usage Information Since this command is enabled by default, it does not appear in the running configuration. When unicast routing is disabled, the no ipv6 unicast-routing command is included in the running configuration. Whenever unicast routing is disabled or re-enabled, FTOS generates a syslog message indicating the action. Disabling unicast routing on an E-Series chassis causes the following behavior: • static and protocol learnt routes are removed from RTM and from the CAM; packet forwarding to these routes is terminated. • connected routes and resolved neighbors remain in the CAM and new IPv6 neighbors are still discoverable • additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no new adjacencies are formed • the IPv6 address family configuration (under router bgp) is deleted • IPv6 Multicast traffic continues to flow unhindered show ipv6 cam linecard c e Displays the IPv6 CAM entries for the specified line card. Syntax show ipv6 cam linecard slot-number port-set {0-1} [summary | index | ipv6 address] 780 | IPv6 Basics