Dell Force10 S4820T FTOS Command Reference Guide - Page 1072
ipv6 nd reachable-time, ipv6 nd suppress-ra, ipv6 neighbor, Reachable Time
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1072 highlights
www.dell.com | support.dell.com ipv6 nd reachable-time e Configure the amount of time that a remote IPv6 node is considered available after a reachability confirmation event has occurred. The description of reachable time from RFC 2461 (http://tools.ietf.org/html/rfc2461) is: Syntax Reachable Time: 32-bit unsigned integer. The time, in milliseconds, that a node assumes a neighbor is reachable after having received a reachability confirmation. Used by the Neighbor Unreachability Detection algorithm. A value of zero means unspecified (by this router). ipv6 nd reachable-time {milliseconds} To restore the default time, use the no ipv6 nd reachable-time command. Parameters milliseconds Enter the leachability time in milliseconds. Range: 0 to 3600000 Defaults 3600000 milliseconds Command Modes INTERFACE ipv6 nd suppress-ra e Suppress the IPv6 router advertisement transmissions on an interface. Syntax ipv6 nd suppress-ra To enable the sending of IPv6 router advertisement transmissions on an interface, use the no ipv6 nd suppress-ra command. Defaults Enabled Command Modes INTERFACE ipv6 neighbor e Configure a static entry in the IPv6 neighbor discovery. Syntax ipv6 neighbor {ipv6-address} {interface interface} {hardware_address} To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor {ipv6-address} {interface interface} command. 1072 | Neighbor Discovery Protocol (NDP)