Dell Force10 S4820T FTOS Command Reference Guide - Page 1069

ipv6 nd managed-config-flag e Set the managed address configuration flag in the IPv6 router advertisement. The description of this flag from RFC 2461 (http://tools.ietf.org/html/rfc2461) is: M: 1-bit "Managed address configuration" flag. When set, hosts use the administered (stateful) protocol for address autoconfiguration in addition to any addresses autoconfigured using stateless address autoconfiguration. The use of this flag is described in: Syntax Thomson, S. and T. Narten, "IPv6 Address Autoconfiguration", RFC 2462, December 1998. ipv6 nd managed-config-flag To clear the flag from the IPv6 router advertisements, use the no ipv6 nd managed-config-flag command. Defaults The default flag is 0. Command Modes INTERFACE ipv6 nd max-ra-interval e Configure the interval between the IPv6 router advertisement (RA) transmissions on an interface. Syntax ipv6 nd max-ra-interval {interval} min-ra-interval {interval} To restore the default interval, use the no ipv6 nd max-ra-interval command. Parameters max-ra-interval {interval} min-ra-interval {interval} Enter the keyword max-ra-interval followed by the interval in seconds. Range: 4 to 1800 seconds Enter the keyword min-ra-interval followed by the interval in seconds. Range: 3 to 1350 seconds Defaults Max RA interval: 600 seconds, Min RA interval: 200 seconds Command Modes INTERFACE ipv6 nd mtu c e s Syntax Configure an IPv6 neighbor discovery. ipv6 nd mtu number Neighbor Discovery Protocol (NDP) | 1069