Dell Force10 S4820T FTOS Command Reference Guide - Page 720

www.dell.com | support.dell.com Destination Gateway First-Hop Mac-Addr Port VId EC 10.10.10.10/32 Direct, Nu 0 00:00:00:00:00:00 BLK HOLE 0 0 0.0.0.0 FTOS> Table 24-11. show ip fib linecard Command Example Fields Field Destination Gateway First-Hop Mac-Addr Port VId EC Description Lists the destination IP address. Displays either the word Direct and an interface for a directly connected route or the remote IP address to be used to forward the traffic. Displays the first hop IP address. Displays the MAC address. Displays the egress-port information. Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed. Displays the number of ECMP paths. Related Commands clear ip fib linecard Clear FIB entries on a specified line card. show ip flow c e s Show how a Layer 3 packet is forwarded when it arrives at a particular interface. Syntax Parameters show ip flow interface [vrf vrf instance] interface {source-ip address destination-ip address} {protocol number [tcp | udp] | icmp} {src-port number destination-port number} vrf instance interface interface E-Series Only: Show only the L3 flow as they apply to that VRF process. Enter the keyword interface followed by of the following interface keywords. • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. (OPTIONAL) Enter an in or out parameter in conjunction with the optional interface: 720 | IPv4 Routing