Dell Force10 S4820T FTOS Command Reference Guide - Page 1102
mib-binding, network area
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1102 highlights
www.dell.com | support.dell.com Command History Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced support for Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series mib-binding c e s Enable this OSPF process ID to manage the SNMP traps and process SNMP queries. Syntax mib-binding To mib-binding on this OSPF process, enter no mib-binding. Defaults None. Command Modes ROUTER OSPF Command History Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Introduced on S4820T Introduced on S4810 Introduced to all platforms. Usage Information This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the first OSPF process will be used. If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility. network area c e s Define which interfaces run OSPF and the OSPF area for those interfaces. Syntax network ip-address mask area area-id To disable an OSPF area, use the no network ip-address mask area area-id command. Parameters ip-address mask area-id Specify a primary or secondary address in dotted decimal format. The primary address is required before adding the secondary address. Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range: 0 to 65535 IP address format: dotted decimal format A.B.C.D. Note: If the area ID is smaller than 65535, it will be converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1. 1102 | Open Shortest Path First (OSPFv2)