Dell Force10 S4820T FTOS Command Reference Guide - Page 1376

www.dell.com | support.dell.com Parameters Defaults Command Modes Related Commands • Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any | host ip-address} command. ip ip-protocol-number source mask any host ip-address destination count bytes log order number Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that the access list will deny all IP protocols. Enter a number from 0 to 255 to deny based on the protocol identified in the IP protocol header. Enter the IP address of the network or host from which the packets were sent. (OPTIONAL) Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword bytes to count only bytes processed by the filter. (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file. (OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as the order number. Not configured. TRACE LIST deny tcp deny udp ip trace-group Assign a trace list filter to deny TCP packets. Assign a trace list filter to deny UDP packets. Create a trace list. deny tcp e Syntax Configure a filter that drops TCP packets meeting the filter criteria. deny tcp {source address mask | any | host ip-address} [operator port [port]] {destination mask | any | host ip-address} [operator port [port]] [count [byte]] | log] [order number] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no deny tcp {source mask | any | host ip-address} {destination mask | any | host ip-address} command. 1376 | Security