Dell Force10 S4820T FTOS Command Reference Guide - Page 1137

timers throttle lsa all Configure LSA transmit intervals. Syntax Parameters Defaults Command Modes Command History Usage Information timers throttle lsa all {start-interval | hold-interval | max-interval} To return to the default, enter no timers throttle lsa. start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. Range: 0-600,000 milliseconds Set the next interval to send the same LSA. This is the time between sending the same LSA after the start-interval has been attempted. Range: 1-600,000 milliseconds Set the maximum amount of time the system waits before sending the LSA. Range: 1-600,000 milliseconds start-interval : 0 msec hold-interval : 5000 msec max-interval: 5000 msec ROUTER OSPF Version 8.3.19.0 Version 8.3.8.0 Introduced on S4820T Introduced on S4810 LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached. timers throttle lsa arrival Configure the LSA acceptance intervals. Syntax timers throttle lsa arrival arrival-time To return to the default, enter no timers throttle lsa. Open Shortest Path First (OSPFv2) | 1137