Dell Force10 S4820T FTOS Command Reference Guide - Page 633
Table 23-5., Lines in show interfaces Command Example EtherScale, Description
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 633 highlights
Example Note: In the CLI output, the power value will be rounded to a 3-digit value. For receive/transmit power that is less than 0.000, an snmp query will return the corresponding dbm value even though the CLI displays as 0.000. Note: After the counters are cleared, the line-rate continues to increase until it reaches the maximum line rate. When the maximum line rate is reached, there will be no change in the line-rate. FTOS#show interfaces TenGigabitEthernet 2/0 is down, line protocol is down Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7 Current address is 00:01:e8:8b:3d:e7 Pluggable media present, Media type is unknown Wavelength unknown Interface index is 100992002 Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed auto Flowcontrol rx on tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 3d17h53m Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 0 packets, 0 bytes, 0 underruns 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 collisions, 0 wreddrops Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 3d17h51m Table 23-5. Lines in show interfaces Command Example (EtherScale) Line TenGigabitEthernet 2/0... Hardware is... Interface index... Internet address... MTU 1554... LineSpeed Description Displays the interface's type, slot/port, and administrative and line protocol status. Displays the interface's hardware information and its assigned MAC address. Displays the interface index number used by SNMP to identify the interface. States whether an IP address is assigned to the interface. If one is, that address is displayed. Displays link and IP MTU information. If the chassis is in Jumbo mode, this number can range from 576 to 9252. Displays the interface's line speed. Interfaces | 633