Dell Force10 S4820T FTOS Command Reference Guide - Page 37

Parameters Defaults Command Modes Command History Usage Information cp linecard linecard-slot rp Enter the keyword cp to change the bootflash image on the Control Processor on the RPM. Enter the keyword linecard followed by the slot number to change the bootflash image on a specific line card. C-Series Range: 0-7 E-Series Range: 0 to 13 on the E1200; 0 on 6 on the E600, and 0 to 5 on the E300. Enter the keyword rp to change the bootflash image on the RPM Route Processor. Not configured. EXEC Privilege Version 7.5.1.0 Introduced on C-Series E-Series original Command A system message appears stating that the bootflash image has been changed. You must reload the system before the system can switch to the new bootflash image. copy c e s Syntax Parameters Command Modes Copy one file to another location. FTOS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP (in the hostip field). copy source-file-url destination-file-url file-url Enter the following location keywords and information: • To copy a file from the internal FLASH, enter flash:// followed by the filename. • To copy a file on an FTP server, enter ftp://user:password@hostip/filepath • To copy a file from the internal FLASH on RPM0, enter rpm0flash://filepath • To copy a file from the external FLASH on RPM0, enter rpm0slot0://filepath • To copy a file from the internal FLASH on RPM1, enter rpm1flash://filepath • To copy a file from the external FLASH on RPM1, enter rpm1slot0://filepath • To copy the running configuration, enter the keyword running-config. • To copy the startup configuration, enter the keyword startup-config. • To copy using Secure Copy (SCP), enter the keyword scp: (If scp: is entered in the source position, then enter the target URL; If scp: is entered in the target position, first enter the source URL; refer to the examples below.) • To copy a file on the external FLASH, enter slot0:// followed by the filename. • To copy a file on a TFTP server, enter tftp://hostip/filepath ExaScale only • To copy a file from a USB drive on RPM0, enter rpm0usbflash://filepath • To copy a file from an external USB drive, enter usbflash://filepath EXEC Privilege File Management | 37