Dell Force10 S4820T FTOS Command Reference Guide - Page 657

Related Commands interface ManagementEthernet duplex (Management) management route Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. stack-unit portmode Split a single 40G port into 4-10G ports on the S4810, S4820T, or Z9000. z Syntax stack-unit stack-unit port number portmode quad Parameters stack-unit number Enter the stack member unit identifier of the stack member to reset. S4810 and S4820T range: 0 to 11 Z9000 range: 0 to 7 Note: The S4810 and S4820T commands accept Unit ID numbers 0-11, though S4810 supports stacking up to 3 units only with FTOS version 8.3.7.1. Enter the port number of the 40G port to be split. S4810 S4820T range: Enter one of the following port numbers: 48, 52, 56, or 60. Z9000 range: 0 to 124 in multiples of 4 (0, 4, 8, 12, ... 120 124) Defaults Disabled Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.1 Introduced on S4820T. Introduced on Z9000. Introduced on S4810. Usage Information Splitting a 40G port into 4x10G port is supported only on a standalone unit. • Split ports cannot be used as stack-link to stack an S4810 or S4820T. • Split ports S4810 or S4820T units cannot be a part of any stacked system. • The unit number with the split ports must be the default (stack-unit 0) • This can be verified using CLI "show system brief". If the unit ID is different than 0, then it must be renumbered to 0 before ports are split. By using the stackunit id renumber 0 command in EXEC mode. The quad port must be in a default configuration before it can be split into 4x10G ports. The 40G port is lost in the config when the port is split, so be sure the port is also removed from other L2/L3 feature configurations. The system must be reloaded after issuing the CLI for the change to take effect. Interfaces | 657