Dell Force10 S4820T FTOS Command Reference Guide - Page 1182
source port monitoring
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1182 highlights
www.dell.com | support.dell.com source (port monitoring) c e s Configure a port monitor source. Syntax source interface destination interface direction {rx | tx | both} To disable a monitor source, use the no source interface destination interface direction {rx | tx | both} command. Parameters interface destination direction {rx | tx | both} Enter the one of the following keywords and slot/port information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. Enter the keyword destination to indicate the interface destination. Enter the keyword direction followed by one of the packet directional indicators. rx: to monitor receiving packets only tx: to monitor transmitting packets only both: to monitor both transmitting and receiving packets Defaults No default behavior or values Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.5.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.5.1.0 Version 7.4.1.0 Added support for 4-port 40G line cards on ExaScale. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Usage Information FTOS(conf-mon-sess-11)#source gi 10/0 destination gi 10/47 direction rx FTOS(conf-mon-sess-11)# Note: A SONET port can only be configured as a monitored port. 1182 | Port Monitoring