Dell Force10 S4820T FTOS Command Reference Guide - Page 365

Parameters Defaults Command Modes Usage Information Command History process-id match external {1 | 2} match internal route-map map-name Enter the number of the OSPF process. Range: 1 to 65535 (OPTIONAL) Enter the keywords match external to redistribute OSPF external routes. You can specify 1 or 2 to redistribute those routes only. (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal routes only. (OPTIONAL) Enter the keywords route-map followed by the name of a configured Route map. Not configured. ROUTER BGP With FTOS version 8.3.1.0 and later, the redistribute command can be used to advertise the IGP cost as the MED on redistributed routes. When the route-map is set with metric-type internal and applied outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-group will have IGP cost set as MED. When you enter redistribute isis process-id command without any other parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This feature is not supported by an RFC. Version 8.3.19.0 Version 8.3.7.0 Version 8.3.1.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced ability to substitute IGP cost for MED when a peer/ peer-group outbound route-map is set as internal. Introduced support on S-Series Introduced support on C-Series router bgp c e s Enter ROUTER BGP mode to configure and enable BGP. Syntax Parameters Defaults router bgp as-number To disable BGP, use the no router bgp as-number command. as-number Enter the AS number. Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte) or 0.1-65535.65535 (Dotted format) Not enabled. Border Gateway Protocol IPv4 (BGPv4) | 365