Dell Force10 S4820T FTOS Command Reference Guide - Page 971

Parameters Command Modes Command History Example Usage Information Example (show mac-address-table) linecard slot port-set port-pipe EXEC EXEC Privilege (REQUIRED) Enter the keyword linecard followed by a slot number to select the linecard for which to gather information. C300 range: 0 to 7; C150 range: 0 to 4 (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number to select the Port-Pipe for which to gather information. Range: 0 or 1 Version 7.6.1.0 Introduced on C-Series FTOS#show cam maccheck linecard 2 port-set 0 Dumping entries. From 0 to 16383. Progress . marks 100 memory table entries Index 5576 (0x15c8) has valid entries (H: 2b9, E: 0) ..........Index 6592 (0x19c0) has valid entries (H: 338, E: 0) output truncated Use this command to check various flags associated with each MAC address in the CAM. The example above shows information for two MAC addresses. The second entry is for MAC address 00:00:a0:00:00:00 (leading 0s are not shown), which is shown as learned on VLAN ID 4094 (0xfff), as shown below in the example for show mac-address-table and the example for show cam mac linecard. Above, "STATIC_BIT=0" means that the address is dynamically learned. When an entry is listed as STATIC_BIT=1, its HIT_SA is 0, which signifies that this address is not getting continuously learned trough traffic. The HIT_DA is set when a new learn happens, and after the first age sweep, it gets reset. FTOS#show mac-address-table VlanId Mac Address 4094 00:00:a0:00:00:00 Type Interface Dynamic Gi 2/0 output truncated State Active Layer 2 | 971