Dell Force10 S4820T FTOS Command Reference Guide - Page 1399

Defaults Command Modes Command History Usage Information number max-datagram-size number Not configured CONFIGURATION (OPTIONAL) Enter the UDP port number (User Datagram Protocol). Range: 0 to 65535 Default: 6343 (OPTIONAL) Enter the keyword max-datagram-size followed by the size number in bytes. Range: 400 to 1500 Default: 1400 Version 8.3.19.0 Version 8.4.2.3 Version 8.4.1.1 Version 8.3.7.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.5.1.0 Version 6.2.1.1 Introduced on S4820T Support for IPv6 sFlow collectors and agents was added on the E-series TeraScale, C-Series, and S-Series. Support for IPv6 sFlow collectors and agents was added on the E-series ExaScale. Introduced on S4810 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Expanded the no form of the command to mirror the syntax used to configure Introduced on E-Series You can configure up to two sFlow collectors (IPv4 or IPv6). If two collectors are configured, traffic samples are sent to both. The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identify the sFlow agent. IPv6 sFlow collectors and agents are supported on E-Series (ExaScale and TeraScale), C-Series, and S-Series routers. To delete a configured collector, enter the no sflow collector {ipv4-address | ipv6-address} agent-addr {ipv4-address | ipv6-address} [number [max-datagram-size number]] | [max-datagram-size number] command. As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS will return the corresponding configured agent IP in MIB requests. FTOS checks to ensure that two entries are not configured for the same collector IP with a different agent IP. Should that happen, FTOS generates the following error: %Error: Different agent-addr attempted for an existing collector sFlow | 1399