Dell Force10 S4820T FTOS Command Reference Guide - Page 1524

www.dell.com | support.dell.com Command Modes Usage Information Command History VLT DOMAIN After you configure the VLT domain on each peer switch on both sides of the interconnect trunk, by default, the FTOS software elects a primary and secondary VLT peer device. Use the priority command to reconfigure the primary role of VLT peer switches. Version 8.3.19.0 Version 8.3.8.0 Introduced on S4820T Introduced on S4810 show vlt z Displays status information about VLT domains currently configured on the switch. Syntax Defaults Command Modes Example (brief) Example (detail) Command History Usage Information show vlt [brief | detail] Not configured. EXEC FTOS(conf)#show vlt brief VLT Domain Brief Domain ID: Role: Role Priority: ICL Link Status: HeartBeat Status: VLT Peer Status: Version: Local System MAC address: Remote System MAC address: Remote system version: 10 Primary 32768 Up Not Established Up 5(1) 00:01:e8:8b:14:3c 00:01:e8:8b:15:20 5 (1) FTOS# FTOS(conf-if-vl-100)#show vlt detail Local LAG Id Peer LAG Id Local Status Peer Status 10 10 UP UP 400, Active VLANs 100, 200, 300 Version 8.3.19.0 Version 8.3.12.0 Version 8.3.8.0 Introduced on S4820T Support added for number of VLT instances on S4810. For show vlt brief, added support in output for version and delay restore timer. For show vlt detail, added support in output for local LAG status and remote LAG status. Introduced on S4810. The version shown in the show vlt brief output displays the VLT version number which is different from the FTOS version number. VLT version numbers are begin with odd numbers such as 3 or 5. 1524 | Virtual Link Trunking (VLT)