Dell Force10 S4820T FTOS Command Reference Guide - Page 846

www.dell.com | support.dell.com Command History Usage Information Related Commands Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale If you do not configure default-metric command, in addition to the redistribute command, or there is no route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0::0/0) configure the neighbor default-originate command. neighbor default-originate Inject the default route. redistribute isis c e Redistribute IS-IS routes into BGP. Syntax Parameters Defaults Command Modes redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value | metric-type {external | internal}] [route-map map-name] To stop redistribution of IS-IS routes, use the no redistribute isis command. level-1 | level-1-2 | level-2] metric metric-type route-map map-name (OPTIONAL) Enter the type (level) of routes to redistribute. (OPTIONAL) Assign metric to an interface for use with IPv6 information (OPTIONAL) The external link type associated with the default route advertised into a routing domain. You must specify one of the following: • external • internal (Default) (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGPV6-ADDRESS FAMILY 846 | IPv6 Border Gateway Protocol (IPv6 BGP)