Dell Force10 S4820T FTOS Command Reference Guide - Page 437

Syntax Parameters Command Modes Command History Usage Information cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number] ipv4pbr number [fcoeacl number iscsioptacl number]} default l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number] ipv4pbr number [fcoeacl number iscsioptacl number] CONFIGURATION Use the default CAM profile settings, and set the CAM as follows. L3 ACL (ipv4acl): 4 L2 ACL(l2acl): 5 IPv6 L3 ACL (ipv6acl): 0 L3 QoS (ipv4qos): 1 L2 QoS (l2qos): 1 Allocate space to each CAM region. Enter the CAM profile name followed by the amount of CAM space to be allotted. The total space allocated must equal 13 blocks. The range for ipv4acl is 1 to 4. The ipv6acl range must be a factor of 2. Version 8.3.19.0 Version 8.3.19.0 Version 8.3.19.0 Version 8.3.12.0 Version 8.3.10.2 Version 8.3.10.0 Version 8.3.1.0 Version 8.2.1.0 Version 7.8.1.0 Added fcoeacl and iscsioptacl keywords for S4820T. Clarified block information for S4820T. Introduced on S4820T. Added fcoeacl and iscsioptacl keywords for S4810. Clarified block information for S4810. Introduced on S4810. Added ecfmacl, vman-qos, and vman-dual-qos keywords. Introduced on the S-Series. Introduced on the C-Series. You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks that cannot be reallocated. The ipv4acl profile range is 1 to 4. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. On the S4810 and the S4820T, there can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported. Ranges for the CAM profiles are 1 to 10, except for the ipv6acl profile which is 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM regions, the value is 0. Content Addressable Memory (CAM) | 437