Dell Force10 S4820T FTOS Command Reference Guide - Page 1517

Example (Tagged VLAN) Example (Tagged & Untagged VLANs) In Example 2 below, the Tag Protocol Identifier (TPID) is set to 8848. The "Gi 3/10" port is configured to act as a VLAN-Stack access port, while the "TenGi 8/0" port will act as a VLAN-Stack trunk port, switching Stackable VLAN traffic for VLAN 10, while also switching untagged traffic for VLAN 30 and tagged traffic for VLAN 40. (To allow VLAN 30 traffic, the native VLAN feature is required, by executing the portmode hybrid command. Refer to portmode hybrid in Interfaces. FTOS(conf-if-gi-0/42)#switchport FTOS(conf-if-gi-0/42)#vlan-stack trunk FTOS(conf-if-gi-0/42)#show config ! interface GigabitEthernet 0/42 no ip address switchport vlan-stack trunk no shutdown FTOS(conf-if-gi-0/42)#interface vlan 100 FTOS(conf-if-vl-100)#vlan-stack compatible FTOS(conf-if-vl-100-stack)#member gigabitethernet 0/42 FTOS(conf-if-vl-100-stack)#show config ! interface Vlan 100 no ip address vlan-stack compatible member GigabitEthernet 0/42 shutdown FTOS(conf-if-vl-100-stack)#interface vlan 20 FTOS(conf-if-vl-20)#tagged gigabitethernet 0/42 FTOS(conf-if-vl-20)#show config ! interface Vlan 20 no ip address tagged GigabitEthernet 0/42 shutdown FTOS(conf-if-vl-20)#do show vlan Codes: * - Default VLAN, G - GVRP VLANs Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Vlan-stack NUM Status Description * 1 Inactive 20 Active 100 Active FTOS(conf-if-vl-20)# FTOS(config)#vlan-stack protocol-type 88A8 FTOS(config)#interface gigabitethernet 3/10 FTOS(conf-if-gi-3/10)#no shutdown FTOS(conf-if-gi-3/10)#switchport FTOS(conf-if-gi-3/10)#vlan-stack access FTOS(conf-if-gi-3/10)#exit Q Ports T Gi 0/42 M Gi 0/42 FTOS(config)#interface tenGigabitethernet 8/0 FTOS(conf-if-te-10/0)#no shutdown VLAN Stacking | 1517