Dell Force10 S4820T FTOS Command Reference Guide - Page 734

www.dell.com | support.dell.com Usage Information Related Commands 31 UDP any 162 Q7 6 No - CP 32 UDP 162 any Q7 6 No - CP 33 PIM-SM any any Q6 0 No - RP2 34 IGMP any any Q7 6 No - RP2 35 OSPF any any Q7 6 No - RP1 36 RSVP any any Q7 6 No - RP1 FTOS# The IPPTT table is used for looking up forwarding information for IP control traffic destined to the router. For the listed control traffic types, IPPTT contains the information for the following: • Which CPU to send the traffic (CP, RP1, or RP2) • What QoS parameters to set show ip cam stack-unit Display the CAM table show tcp statistics c e s View information on TCP traffic through the switch. Syntax Parameters Command Modes Command History Example show tcp statistics {all | cp | rp1 | rp2} all Enter the keyword all to view all TCP information. cp Enter the keyword cp to view only TCP information from the Control Processor. rp1 Enter the keyword rp1 to view only TCP statistics from Route Processor 1. rp2 Enter the keyword rp2 to view only TCP statistics from Route Processor 2. EXEC Privilege Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 6.4.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced FTOS#show tcp stat cp Control Processor TCP: Rcvd: 10585 Total, 0 no port 0 checksum error, 0 bad offset, 0 too short 329 packets (1263 bytes) in sequence 17 dup packets (6 bytes) 0 partially dup packets (0 bytes) 7 out-of-order packets (0 bytes) 0 packets ( 0 bytes) with data after window 0 packets after close 0 window probe packets, 41 window update packets 41 dup ack packets, 0 ack packets with unsend data 734 | IPv4 Routing