Dell Force10 S4820T FTOS Command Reference Guide - Page 697

Command History Usage Information Related Commands Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.3.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series This command disables the incrementing of the hops field when boot requests are relayed to a DHCP server through FTOS. If the incoming boot request already has a non-zero hops field, the message will be relayed with the same value for hops. However, the message will be discarded if the hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542. ip helper-address show running-config Specify the destination broadcast or host address for DHCP server requests. Display the current configuration and changes from default values. ip host c e s Assign a name and IP address to be used by the host-to-IP address mapping table. Syntax Parameters Defaults Command Modes Command History ip host name ip-address To remove an IP host, use the no ip host name [ip-address] command. name ip-address Enter a text string to associate with one IP address. Enter an IP address, in dotted decimal format, to be mapped to the name. Not configured. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series IPv4 Routing | 697