Dell Force10 S4820T FTOS Command Reference Guide - Page 946

www.dell.com | support.dell.com Usage Information Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are not, you can verify the specified area addresses of the routers by using the show isis neighbors command. show isis protocol e Display IS-IS routing information. Syntax show isis protocol Command Modes EXEC EXEC Privilege Command History Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T Introduced on S4810 Example Figure 29-9. Command Example: show isis protocol FTOS#show isis protocol IS-IS Router: System Id: F100.E120.0013 IS-Type: level-1-2 Manual area address(es): 49.0000.0001 Routing for area address(es): 49.0000.0001 Interfaces supported by IS-IS: GigabitEthernet 1/0 - IP - IPv6 GigabitEthernet 1/1 - IP - IPv6 GigabitEthernet 1/10 - IP - IPv6 Loopback 0 - IP - IPv6 Redistributing: Distance: 115 Generate narrow metrics: level-1-2 Accept narrow metrics: level-1-2 Generate wide metrics: none Identifies that MT IS-IS is enabled. Accept wide metrics: none Multi Topology Routing is enabled in transition mode. FTOS# show isis traffic e This command enables you to display IS-IS traffic interface information. Syntax show isis traffic [interface] 946 | Intermediate System to Intermediate System (IS-IS)