Dell Force10 S4820T FTOS Command Reference Guide - Page 1167

Command History Usage Information Version 8.3.19.0 Version 8.3.12.0 Version 7.4.1.0 Introduced on S4820T Introduced on the S4810. Introduced The router with the largest value assigned to an interface becomes the Designated Router. If two interfaces contain the same DR priority value, the interface with the largest interface IP address becomes the Designated Router. ipv6 pim join-filter e Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group. Syntax ipv6 pim join-filter access-list Parameters access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults None Command Modes INTERFACE Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.1.0 Introduced on S4820T Introduced on the S4810. Introduced Example FTOS(conf)#ipv6 access-list JOIN-FIL_ACL FTOS(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::225:1:2:0/112 FTOS(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112 FTOS(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any FTOS(conf-ipv6-acl)#exit FTOS(conf)#interface gigabitethernet 0/84 FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out ipv6 pim query-interval e Change the frequency of IPv6 PIM Router-Query messages. Syntax ipv6 pim query-interval seconds To return to the default value, enter no ipv6 pim query-interval seconds command. PIM-Sparse Mode (PIM-SM) | 1167