Dell Force10 S4820T FTOS Command Reference Guide - Page 522

www.dell.com | support.dell.com ip ecmp-group Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route. Syntax ip ecmp-group {maximum-paths | {number} {path-fallback} To negate a command, use the no command. For example no ip ecmp-group maximum-paths {number} Parameters maximum-paths path-fallback Specify the maximum number of ecmp for a route. Range: 2 to 64 Use the keyword path-fallback to enable this feature. If the feature is enabled, re-enter this keyword to disable the feature. Defaults 16 Command Modes CONFIGURATION Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.10.0 Introduced on S4810 Usage Information You must save the new ECMP settings to the startup-config (write-mem) then reload the system for the new settings to take effect. Related Commands show ip cam stack-unit Display content-addressable memory (CAM) entries for an S-Series switch. link-bundle-monitor enable Provides a mechanism to enable monitoring of traffic distribution on an ECMP link bundle. Syntax Command Modes Command History link-bundle-monitor enable To exit from ecmp group mode, use the exit command. ECMP-GROUP PORT-CHANNEL INTERFACE Version 8.3.19.0 Version 8.3.10.0 Introduced on S4820T Introduced on S4810 522 | Equal Cost Multi-Path